| Front Panel: |
|
RF In: 'F', female, 75 ohm impedance, RF from CATV system, iCC-Net control |
|
RF Out: 'F', female, 75 ohm impedance, RF to TV |
|
Low-loss internal tap - less than -1.5 dB loss |
|
Net LED: Green LED for iC-Net bus and DC power, flashes once per second if active |
|
IR Out: 3.5mm jack for CC-IRE IR Emitter cable |
|
Supports carrier frequencies up to 62 KHz |
|
IR Out LED: Red LED lights when sending IR commands |
|
Power Sensor: |
|
Tip+:3.5mm jack for 5V logic-level input |
|
CSM: Current Sensing Monitor - 3.5mm jack for USB to Type A USB connector, 5-12 VDC |
|
LED: Red LED lights when sensor indicates power on |
|
Power In: 2.1mm coaxial jack (inside center conductor positive), 75 mA maximum |
|
11.5 to 16.5 VDC, 12 VDC typical (may be unregulated) |
|
DIP Switches S1 and S2: Located on bottom of unit, sets IR code operation and device number |
|
ICC-Net: |
|
Operation: 1-way control, carried over the same RF coax connection as TV channels |
|
Data Receive: Mid-band VHF, 74.7MHz, sent from IC Head-End Network Controller , -25 to +35 dBmV signal level |
|
Additional Specs: |
|
Size: 5.5" [140mm] wide x 1.1" [28mm] high x 3.4" [86mm] deep |
|
Weight: 8 oz [226g] |
|
Enclosure: All aluminum with durable black powder coat paint |
|
Mounting: Mounts at rear of TV |
|
Included Accessories: Space-saving PS12-500 12 VDC 500 mA digital switching power supply (North American shipments only) , CC-IRE IR Emitter, RF Loop cable, Mounting Velcro for unit |
|
Warranty: 2 Years |